Video Guide: Change Micromanipulator Handedness
Captions
- Carefully remove the screw and spring holder plate from the right side mount.
- Reinstall the spring and holder plate on the opposite, left side using the same screw.
- Remove the screws securing Y axis micrometer mount from the left side.
- Reinstall the Y axis micrometer mount on the opposide, right side using the same screws.
- Remove the screws securing the Y axis push plate.
- Reinstall the Y axis push plate on the right side, using the same screws in the mounting holes closest to the Y-axis micrometer.
- Test to confirm the Y axis motion is restored.
Captions
- Carefully remove the screw and spring holder plate from the left side mount.
- Reinstall the spring and holder plate on the opposite, right side using the same screw.
- Remove the screws securing Y axis micrometer mount from the right side.
- Reinstall the Y axis micrometer mount on the opposide, left side using the same screws.
- Remove the screws securing the Y axis push plate.
- Reinstall the Y axis push plate on the left side, using the same screws in the mounting holes closest to the Y-axis micrometer.
- Test to confirm the Y axis motion is restored. Ensure movement is smooth and the spring applies force to the carriage against the micrometer.
Micromanipulator
Learn More
How to Position the Ossila Micromanipulator Probe
Learn how to accurately adjust your micromanipulator probe.
Read more...
Connecting the Micromanipulator to the Source Measure Unit
This guide gives an overview of how to use the Ossila Micromanipulators with the Source Measure Unit, as well as some general tips and tricks for getting the most out of sensitive electrical probing measurements.
Read more...