FREE shipping to on qualifying orders when you spend or more. All prices ex. VAT.

Norm-Ject Disposable Luer Lock Syringes

Equipment Accessories, General Laboratory Supplies, Solution Making Supplies, Syringe Pumps

Product Code C110
Price $65 ex. VAT

Quality assured

Expert support

Volume discounts

Worldwide shipping

Fast and secure

Solvent-resistant disposable syringes for solution preparation and filtration

High-quality syringes available to purchase in different sizes

Ossila offer a range of Norm-Ject™ Luer lock disposable all plastic (solvent-resistant)  syringes for solution preparation and filtration.

Norm-Ject two-part syringes are one of the few made solely from virgin-grade polypropylene plastic. This means that unlike most syringes, Norm-Ject syringes form a tight seal without needing a rubber plunger. This is important when working with solutions that are incompatible with rubber seals (e.g. acids and chlorinated solvents).

In addition, these syringes come with Luer lock attachments (1 ml Luer slip only), allowing for the secure addition of needles and filters. The syringes are individually packed and sterile in unopened, undamaged packages.

Norm-Ject syringes are compatible with both the Ossila Single Syringe Pump and Dual Syringe Pump.

Syringe Pumps

Test chips optimized for 2D materials
  • High Quality
  • Single and Dual Models
  • Unbeatable Value

Prices from £1900

Available Sizes

We sell solvent-resistant disposable syringes in the sizes below.

Syringe Size Pack Size Material End Fitting Product Code
1 ml 100 PP Luer Slip C110
2 ml (3 ml) 100 PP Luer Lock C111
5 ml (6 ml) 100 PP Luer Lock C112
10 ml (12 ml) 100 PP Luer Lock C113
20 ml (24 ml) 100 PP Luer Lock C114
30 ml (35 ml) 50 PP Luer Lock C115
50 ml (60 ml) 30 PP Luer Lock C116

Usage Demonstration

In this video, an Ossila syringe filter is used with a C112 disposable syringe to filter PEDOT:PSS in preparation for spin coating onto a substrate.

Getting a high quality PEDOT:PSS film is critical for effective device performance and is often the most difficult part of device fabrication. PEDOT:PSS requires a pristine and hydrophilic surface in order to coat properly, which should have been achieved with the cleaning routine above. It is also critical to ensure that the active areas have not come into contact with any other surfaces as this will affect how well the ITO will spin.

The grade and composition of PEDOT:PSS is also very important. We use Heraeus CleviosTM P AI 4083 which is filtered prior to use through a 0.45 μm PES filter. It is very important to use a rubber-free syringe as many rubbers are attacked by the acidic nature of the PEDOT:PSS.

Low Price PES, PTFE, PVDF & Nylon Filters

  • Compatible with Norm-Ject syringes
  • Low Price

Available From £46

To the best of our knowledge the information provided here is accurate. However, Ossila assume no liability for the accuracy of this page. The values provided are typical at the time of manufacture and may vary over time and from batch to batch. Products may have minor cosmetic differences (e.g. to the branding) compared to the photos on our website. All products are for laboratory and research and development use only, and may not be used for any other purpose including health care, military, pharmaceuticals, cosmetics, food, or commercial applications.

Return to the top