Video: How to Load the Low Density OFET Evaporation Stack

This video demonstrates how to load up the low density OFET stack ready to thermally evaporate (vacuum deposit) the source-drain contacts (compatible with most common OFET architectures such as top/bottom gate and top/bottom contacts).Loading the evaporation stack consists of the below steps:

Loading the thin flexible mask onto the rigid lower support.

Loading the substrate support holder on top of the mask

Loading a substrate into the substrate support

Adding the magnetic sheet to hold the substrate and mask in close contact

Screwing the lid on to make a mechanically robust system ready for evaporation

Start making OFETsView ourlow density OFET overview and schematic or contact our OFET team.

This video demonstrates how to load up the low density OFET stack ready to thermally evaporate (vacuum deposit) the source-drain contacts (compatible with most common OFET architectures such as top/bottom gate and top/bottom contacts).

Loading the evaporation stack consists of the below steps:

Loading the thin flexible mask onto the rigid lower support.
Loading the substrate support holder on top of the mask
Loading a substrate into the substrate support
Adding the magnetic sheet to hold the substrate and mask in close contact
Screwing the lid on to make a mechanically robust system ready for evaporation

Start Making OFETs

View our low density OFET overview and schematic or contact our OFET team.

Return to the top